Tag Archives: Auto Repair 46544

How long can you drive on a noisy Wheel Bearing?

How long can you drive on a noisy Wheel Bearing?

How long can you drive on a noisy Wheel Bearing? That’s a hard question to answer, the average life of Wheel Bearings is about 5- 10 years or about 100,000 miles. When the Bearings go bad they affect other areas of your Vehicle. For example, the wear on your Tires may be uneven and need to be replaced sooner then later. Also, the ride can become pretty rough and bumpy. That can compromise yours and others on the road. Ignoring the grinding, or rumbling sounds, (Wheel Bearing Sound) or the clicking that can occur during acceleration. Are you noticing a vibrating or loose Steering Wheel? You might also experience a pulling when applying the Brakes. Which can cause uneven Rotor and Brake Pad wear, so ignoring the noise can cost you a lot more.   

How do I know if my Wheel Bearing needs replacing?

How do I know if my Wheel Bearing needs replacing?

How do I know if my Wheel Bearing needs replacing? Great question!!  Can you drive a car with a bad Wheel Bearing? It is not safe to drive with a bad Wheel Bearing. When you drive if one of the bearings are worn out it could cause the wheel to stop while driving. The Wheel of your Vehicle is not a simple part. For the Hub, Tire and assemblies to work well the Wheel Bearings are an integral part to the whole. The Wheel Bearing is a set of steel balls held in place by a metal ring. Which then fits into a Hub, fitting tightly inside, and ride on a metal Axle Shaft. The most common symptom is an audible one: you may hear a grinding or grating noise coming from your tire or wheel. The noise gets louder when you accelerate. The other symptom is a loose feeling r less responsive action from the steering. Another aspect with the Steering is that you may notice a pulling or veering to the right or left, not always the Wheel Bearing but a good possibility. Your Tires should be rotated regu ... read more

What happens with bad Rotors

What happens with bad Rotors

When should Rotors be Replaced? Have you noticed a loud noise when braking? When brake the brake pads squeeze the rotor, thus stopping your vehicle. But when the Brake Pads are worn exposing metal it will grind down the Rotors. It may cause warping which when braking your vehicle may wiggle when braking. It is considered very dangerous when your Rotors get to this stage. Your braking becomes less effective. When your vehicle is in our shop we can to a free Brake assessment.  Here are some warning signals of bad brakes. As I said earlier noise when you brake. In the brake pads is a built-in metal tab, when the brakes wear to that point the noise, irritating isn’t it! You can still drive but it is best to have a Technician detect the source of the sound. Does the brake pedal feel different? You may notice that you have to press harder on the pedal. A Soft Pedal could be an indicator of worn pads and rotors. It could also be a problem with the ... read more

Can you drive with worn Brakes?

Can you drive with worn Brakes?

Can you drive with worn Brakes? There are a many components in the Braking System. The Brake Pads rub against the Brake Drums or Brake Rotors, if you hear a grinding or loud noise time to change the Pads. The Brake Rotors or Drums create the friction to stop your Vehicle. You are probably more familiar with the Brake Pedal which is activate by your foot. Starting the whole Braking process. The Pedal starts the Brake Fluid to flow and put pressure on the Brake Pads. The Master Cylinder, holds the Brake Fluid, and is also activated when you press the Brake Pedal. The Brake Pads are connected to the Wheel Cylinders and squeeze the Brake Drums when the fluid flows on them. Brake Lines carry the Brake Fluid from the Master Cylinder reservoir when the pressure on the Brake Pedal is applied. These are some of the Warning Signs – Please don’t ignore them: Your Brake Light comes on Squeal, Squeak or Grinding Noises Wobbling, Vibration or Scraping when you Brake Fluid is leaking ... read more

Is a bad U-Joint dangerous?

Is a bad U-Joint dangerous?

The U-Joint or Universal Joint connects the Driveshaft to the Differential. It is a cross shaped piece, with bearings at each end. It allows for varying angles of the Driveshaft. If you hear a clunking noise when shifting into drive or reverse or even a banking noise when putting in gear. You may also hear a squeaking noise which can happen when the U-Joint loses lubrication. Huge problem is when your Vehicle goes in gear but won’t move you will need to have your Vehicle towed. #UJoint #drivetrain #wontstart #ricksautoservicein #Mishawaka

Do Struts need to be replaced?

Do Struts need to be replaced?

Do Struts need to be replaced? Some people would say no, but in all honesty I personally prefer a smooth ride. It could also be a matter of safety. If experiencing a bumpy ride, or the Steering becomes stiff or harder to turn, it can also sway or lean to one side. You may also be hearing noises such as clunking or a knocking noise.  The Struts and Springs are part of your Vehicles Suspension System. They absorb all the excess bouncing of your Vehicles Suspension System. What the struts house are the Coil Spring, Spring Seats and Shock Absorbers. The Strut Bearing and the Steering Knuckle. The Struts provide the structural support – connecting the upper Strut Bearing to the lower Ball Joint. The Picture below is the  Vehicle that had the Struts and Springs replaced.   

No Crank/No Start or Crank/ No Start?

NO Crank/No Start or Crank/No Start? There are two types of No Starts/. With the start of the Cold season, we’ve got several calls with these problems. Generally, a “no-start” vehicle will either fail to crank or fail to start while cranking. No-start conditions can arise from many locations on the vehicle, including the engine, transmission, grounding wires in any part of the vehicle, battery, alternator and more.  Most vehicles will fail to start at some point. Most common issue is starting and charging system could be bad battery, alternator, battery cable or starter. ONE, of the ways to be on top of that is PROPER MAINTENANCE. Bring your vehicle to a specialist to properly diagnosis the problem. Give us a call 574-255-4724 or go to our website https://www.ricksautoservice.org/appointments  

Schedule an Appointment

Let us know how we can help you. Schedule your appointment online today.